Site Loader
Rock Street, San Francisco

1.
Microwave assisted balloon angioplasty :

MABA
with a helix and mode filter balloon uses the large differences in the
dielectric characteristics (relative permittivity, electrical conductivity) of
high water content (HWC) and low water content (LWC) tissue to preferentially
heat and weld plaque while sparing healthy artery walls. MABA is an minimally
invasive procedure that uses microwave (300 MHz – 300 GHz) to heat the plaque
which makes the plaque thermally fixed in place by compressing it against the
artery wall. The plaque deposition is detected by using fluoroscopy technique.
MABA consists of 2 main systems, they are microwave delivery system and the
catheter system.

We Will Write a Custom Essay Specifically
For You For Only $13.90/page!


order now

 

v  Microwave
delivery system :

Ø  2450MHz signal generator : A microwave signal of
2450MHz frequency is generated using a signal generator.

Ø   Directional
coupler : This is used to divide and distribute the power.

Ø  Two power meters : Here two power meters are used,
one for measuring the forward power and the other one for measuring the
reflected power.

Ø  Co-axial cable : A thin flexible co-axial cable
of  0.034 diameter is used which fits
within a conventional balloon angioplasty catheter and this co-axial cable is
terminated by a radiating antenna which radiates the desired range of
microwaves.

Ø  Thermocouple : This thermocouple is used to measure
the heating temperature.

 

v   Catheter system :

Ø  Balloon
: The catheter is tipped with an inflatable balloon which is made up of nylon
or polyethylene terephthalate (PET). Deionized water is used to inflate the
balloon.

           

            Procedure :

Ø  The
procedure begins by giving local anesthesia to the groin area of the leg.

Ø  Then
the catheter wire is guided through the femoral artery to the site of lesion.

Ø  A
balloon is then guided along then guided along the wire.

Ø  Once
the position of the balloon catheter is established the guide wire is removed
and the same lumen is used to insert the co-axial microwave system.

Ø  The
balloon is then inflated and is ready to deliver the microwave energy.

Ø  When
microwave power between 10-15 watts is delivered it takes approximately 45s for
the LWC tissue (plaque) to heat up.

Ø  After
the end of the microwave power delivery the balloon is deflated.

Ø  Both
the balloon as well as the fluid (deionized water) inside the balloon are
relatively transparent to microwave energy.

Ø  Then
the deflated balloon is withdrawn along with the catheter.

 

 

              Fig 4 : MABA applicator
consisting of an antenna inside a  catheter balloon 1        

                                                                          Fig
:  5 (a)                                                  

                                                                        Fig
: 5 (b)

                                                                         Fig : 5(c)

                                              Fig  5
(a, b, c) : Procedure of MABA  3  

Advantages :

Ø  Chances
of restenosis are less.

Ø  Patient
can return to normal activities shortly after the procedure.

Ø  The
procedure is performed using local anesthesia, which involves fewer risks than
general anesthesia.

2.
Microwave cardiac ablation :

Microwave cardiac ablation (MCA) is an minimally
invasive procedure that works by scarring or destroying tissues of the heart
that triggers or sustains abnormal heart rhythms. MCA is used to treat heart
tissues that allow abnormal electrical conduction by heating it to the point of
inactivation. Microwave antenna that fits within the catheter system can be
positioned close to the diseased tissue. MCA is an important procedure used to
correct heart rhythm problems (arrthymia).

 

 

Procedure
:

Ø  The
procedure begins by giving local anesthesia to the point where the catheter is
being inserted.

Ø  In microwave cardiac ablation catheter are inserted
through the arteries in order to reach the heart. Catheters may be inserted
through groin, shoulder or through neck. 

Ø  More than 1 Catheter wire is guided through the
arteries, to the site of lesion.

Ø  Mapping catheter is used to map the electrical
activities of the diseased cardiac tissue.

Ø  Later the co-axial microwave system is inserted to
create scars on the diseased cardiac tissues.

Ø  Once the procedure is completed the mapping as well
as the ablation catheters are removed.

Ø  The punctured site is ten treated with either direct
pressure or vascular closure device.

                              Fig 6  : Points from where catheter can be inserted 3

 

                                      Fig 7 3 : Ablation Catheter

 

 

 

 

                                           Fig 7 (A, B)  : 
Microwave cardiac ablation 3

 

Advantages :

Ø  Can
lessen or eliminate the heart rhythm problems.

Ø  Allows
to decrease or stop long term medications for heart rhythm problems.

 

 

 1.
Microwave assisted balloon angioplasty :

MABA
with a helix and mode filter balloon uses the large differences in the
dielectric characteristics (relative permittivity, electrical conductivity) of
high water content (HWC) and low water content (LWC) tissue to preferentially
heat and weld plaque while sparing healthy artery walls. MABA is an minimally
invasive procedure that uses microwave (300 MHz – 300 GHz) to heat the plaque
which makes the plaque thermally fixed in place by compressing it against the
artery wall. The plaque deposition is detected by using fluoroscopy technique.
MABA consists of 2 main systems, they are microwave delivery system and the
catheter system.

 

v  Microwave
delivery system :

Ø  2450MHz signal generator : A microwave signal of
2450MHz frequency is generated using a signal generator.

Ø   Directional
coupler : This is used to divide and distribute the power.

Ø  Two power meters : Here two power meters are used,
one for measuring the forward power and the other one for measuring the
reflected power.

Ø  Co-axial cable : A thin flexible co-axial cable
of  0.034 diameter is used which fits
within a conventional balloon angioplasty catheter and this co-axial cable is
terminated by a radiating antenna which radiates the desired range of
microwaves.

Ø  Thermocouple : This thermocouple is used to measure
the heating temperature.

 

v   Catheter system :

Ø  Balloon
: The catheter is tipped with an inflatable balloon which is made up of nylon
or polyethylene terephthalate (PET). Deionized water is used to inflate the
balloon.

           

            Procedure :

Ø  The
procedure begins by giving local anesthesia to the groin area of the leg.

Ø  Then
the catheter wire is guided through the femoral artery to the site of lesion.

Ø  A
balloon is then guided along then guided along the wire.

Ø  Once
the position of the balloon catheter is established the guide wire is removed
and the same lumen is used to insert the co-axial microwave system.

Ø  The
balloon is then inflated and is ready to deliver the microwave energy.

Ø  When
microwave power between 10-15 watts is delivered it takes approximately 45s for
the LWC tissue (plaque) to heat up.

Ø  After
the end of the microwave power delivery the balloon is deflated.

Ø  Both
the balloon as well as the fluid (deionized water) inside the balloon are
relatively transparent to microwave energy.

Ø  Then
the deflated balloon is withdrawn along with the catheter.

 

 

              Fig 4 : MABA applicator
consisting of an antenna inside a  catheter balloon 1        

                                                                          Fig
:  5 (a)                                                  

                                                                        Fig
: 5 (b)

                                                                         Fig : 5(c)

                                              Fig  5
(a, b, c) : Procedure of MABA  3  

Advantages :

Ø  Chances
of restenosis are less.

Ø  Patient
can return to normal activities shortly after the procedure.

Ø  The
procedure is performed using local anesthesia, which involves fewer risks than
general anesthesia.

2.
Microwave cardiac ablation :

Microwave cardiac ablation (MCA) is an minimally
invasive procedure that works by scarring or destroying tissues of the heart
that triggers or sustains abnormal heart rhythms. MCA is used to treat heart
tissues that allow abnormal electrical conduction by heating it to the point of
inactivation. Microwave antenna that fits within the catheter system can be
positioned close to the diseased tissue. MCA is an important procedure used to
correct heart rhythm problems (arrthymia).

 

 

Procedure
:

Ø  The
procedure begins by giving local anesthesia to the point where the catheter is
being inserted.

Ø  In microwave cardiac ablation catheter are inserted
through the arteries in order to reach the heart. Catheters may be inserted
through groin, shoulder or through neck. 

Ø  More than 1 Catheter wire is guided through the
arteries, to the site of lesion.

Ø  Mapping catheter is used to map the electrical
activities of the diseased cardiac tissue.

Ø  Later the co-axial microwave system is inserted to
create scars on the diseased cardiac tissues.

Ø  Once the procedure is completed the mapping as well
as the ablation catheters are removed.

Ø  The punctured site is ten treated with either direct
pressure or vascular closure device.

                              Fig 6  : Points from where catheter can be inserted 3

 

                                      Fig 7 3 : Ablation Catheter

 

 

 

 

                                           Fig 7 (A, B)  : 
Microwave cardiac ablation 3

 

Advantages :

Ø  Can
lessen or eliminate the heart rhythm problems.

Ø  Allows
to decrease or stop long term medications for heart rhythm problems.

 

 

 

 

 

 

 

 

 

Post Author: admin

x

Hi!
I'm Jeremy!

Would you like to get a custom essay? How about receiving a customized one?

Check it out